#6 x 25mm Hobson Snake Eye Security Insert Standard Driver Bit (3.8-3.9mm outside width) ISBED06

About Snake Eye Security Bits

Snake Eye security driver bits are two-pin spanner-style bits that engage two cross-bored holes in a snake-eye security fastener. Used on coin-locked enclosure covers, public-area tamper-evident panels and security-rated electrical fittings. Low-torque drive system.

Frequently Asked Questions

How to Measure

Fastener Length This product has no head, so the length is the overall length - measured from one end to the other.

Sizing Snake Eye security bits are sized by pin diameter and pin-to-pin spacing matched to the snake-eye fastener spec. The two pins on the bit must align with the two holes on the screw face. Low-torque drive system - not for structural fastener work.

How to measure a driver bit Pick the bit by the pin-to-pin centre distance on the two-pin tip. The shank is the bit's clamping end - 1/4" hex is the universal standard across cordless drivers, impact drivers and bit holders. The overall length determines reach: 25mm insert for general use, 50mm to 90mm power bits with a torsion zone for impact drivers, 116mm for Hilti autofeed, long-shank Allen keys for recessed socket cap screws. Cross-check the tip dimension against the screw head before driving - an undersized bit cams out and strips the recess.

Magnetism

This product is magnetised. The tip / cup retains a fastener through alignment and engagement, which speeds work in overhead, awkward or one-handed install scenarios. Across the wider Driving range, magnetised bits, holders and nutsetters speed install by holding the fastener on the tip through alignment; non-magnetised tools are preferred for electronics, magnetic-sensor proximity and any work where stray magnetism on the fastener would cause downstream issues. Check the specification table above for the per-SKU value before ordering for magnetism-sensitive applications.

Resources

About the Brand

Hobson · Hobson Engineering · Australian

Hobson Engineering is a major Australian fastener and tooling supplier, established over 80 years and operating from Sydney with a national distribution footprint. Hobson manufactures and imports its own range of driver bits, hex keys, nutsetters and security driving accessories.

Range: Hobson's Driving range covers Phillips, Hex, Torx, Square and Slot insert bits, magnetic nutsetters, post-hex security Allen keys, snake-eye and pin-in-Torx security driver bits, and 1/4 inch hex shank quick-change bit holders.

Positioning: Trade-grade tooling backed by a long-established Australian engineering supply chain. Often paired with Hobson fastener stock where a single-source supplier is preferred.

Pricing & Delivery

Includes GST, a Tax Invoice and Free Standard Delivery anywhere in Australia.

Buy with Confidence

15+ years selling online · 25,000+ stock lines · 200 million pieces ex-stock in Brisbane QLD.

Disclaimer

Technical data Researched and compiled from numerous industry sources for the sole purpose of providing basic information. All material is advisory only and its use by anyone is entirely voluntary. Reliance on it for any purpose by anyone is at the sole risk of that person, and Bolt and Nut Australia is not responsible for any loss, claim or damages arising therefrom. In developing this information, Bolt and Nut Australia has made a determined effort to present it accurately.

Measurements Sizes are taken from supplier catalogues or hand-measured and should be used as a guide. Minor variation between batches is normal. We only stock Hobson for this product; substituting another brand is rare and would always be confirmed with you first.

Product Photos & PDF Data Sheets Represent the product type, not exact size. PDFs are a reference guide only. Specifications may change without notice.

If you see any problems with any of our specifications or you require additional information please contact us.